Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Search Forums


Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: 2ROTORMOTOR
Forum: How-To's 07-10-2005, 06:35 PM
Replies: 19
Views: 19,059
Posted By 2ROTORMOTOR
Ok that was a while ago, I have since changed my...

Ok that was a while ago, I have since changed my mind about v8 swaps in rx7's. 20b is the way to go no matter what...
Forum: How-To's 05-09-2004, 12:40 AM
Replies: 19
Views: 19,059
Posted By 2ROTORMOTOR
ok starting off, an engine will cost you 3-4.5k,...

ok starting off, an engine will cost you 3-4.5k, the front clip is a hell lot more and a hell lot more expensive... ignition for small block=dist.
ignition for 20b=coil packs, like you mentioned an...
Forum: How-To's 05-08-2004, 04:29 AM
Replies: 19
Views: 19,059
Posted By 2ROTORMOTOR
3500 will barely get you the motor... let alone a...

3500 will barely get you the motor... let alone a rebuild... subframes are expensive but thats not the whole cost of the motor... atleast runnin a carbed v8 you dont need a computer... regardless I...
Forum: How-To's 05-08-2004, 02:19 AM
Replies: 19
Views: 19,059
Posted By 2ROTORMOTOR
20bb can cost upwards of 15k to install. and...

20bb can cost upwards of 15k to install. and thats w.o a rebuild... most likely you wont be able to run twin turbos unless you remove all the solenoid shit.. single turbo is money too...custom...
Forum: How-To's 04-11-2004, 10:41 PM
Replies: 19
Views: 19,059
Posted By 2ROTORMOTOR
well im not a fan of v8 swaps at alll!!!! but it...

well im not a fan of v8 swaps at alll!!!! but it can and has been done before.. they sell mount kits for them, not sure about fd's though, but the hardest part would be fitment.. since its gunna be...
Showing results 1 to 5 of 5

 
Forum Jump