Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Search Forums


Showing results 1 to 25 of 145
Search took 0.03 seconds.
Search: Posts Made By: sidewaysFC
Forum: TECH Support 10-12-2011, 12:06 AM
Replies: 3
Views: 3,942
Posted By sidewaysFC
ok I took the positive battery cable off wile the...

ok I took the positive battery cable off wile the car was running it stalled. but I took it to advanced auto to have it tested they said it was fine but I dont trust them its only puting out 12.75...
Forum: TECH Support 10-11-2011, 05:40 AM
Replies: 3
Views: 3,942
Posted By sidewaysFC
Ill give it a shot tomarow.I started it up after...

Ill give it a shot tomarow.I started it up after I charged the battery it starts and idles like normale but im sure if I took it down the road and put some load on it again it would start sputering...
Forum: TECH Support 10-11-2011, 05:20 AM
Replies: 5
Views: 3,637
Posted By sidewaysFC
is the coolent level senser the one on top of the...

is the coolent level senser the one on top of the radeater?
Forum: TECH Support 10-10-2011, 08:58 PM
Replies: 3
Views: 3,942
Posted By sidewaysFC
bad altornater

I think my altornater is going bad I was driveing down the road today and stoped to get some gas, and when I went to start the car back up my battery was dead. and on the ride home my volt gauge was...
Forum: TECH Support 10-10-2011, 08:49 PM
Replies: 5
Views: 3,637
Posted By sidewaysFC
bleeding it didnt work

bleeding it didnt work
Forum: 2nd Generation 10-07-2011, 12:24 AM
Replies: 0
Views: 1,299
Posted By sidewaysFC
clicking noise!

theres a clicking noise coming from around my o2 sencer area its like click click click click click click right around the header and I dont know what it is:confused:
Forum: TECH Support 10-06-2011, 09:23 PM
Replies: 5
Views: 3,637
Posted By sidewaysFC
I will try bleeding it

I will try bleeding it
Forum: TECH Support 10-05-2011, 04:54 AM
Replies: 5
Views: 3,637
Posted By sidewaysFC
add coolent buzzer !!!

my add coolent buzzer will not stop buzzing. my coolent is fine the buzzer must just be broken or somthing.so were is the buzzer located so I can take it out and smash it with a hammer.
Forum: FAQ 10-04-2011, 04:42 AM
Replies: 5
Views: 14,263
Posted By sidewaysFC
I want to take shot at it,Im very intrested in...

I want to take shot at it,Im very intrested in tuning and it seems like if you know how to tune you can prity much do anything.
Forum: FAQ 10-03-2011, 03:50 AM
Replies: 5
Views: 14,263
Posted By sidewaysFC
so how is this done exactly, you just do a pull...

so how is this done exactly, you just do a pull down the road or on the dyno log it and go in to the the fuel and timing tables on your lap top and change this stuff?cos I want to go full stand alone...
Forum: 2nd Generation 09-21-2011, 02:03 AM
Replies: 9
Views: 5,523
Posted By sidewaysFC
also true the the rear steer can make the car...

also true the the rear steer can make the car unperdictable during drifting I would go with poliyurithane or metal bushings all around to make sure every thing isnt moving around.it will make the car...
Forum: TECH Support 09-19-2011, 03:25 AM
Replies: 4
Views: 3,792
Posted By sidewaysFC
well I took the upper intake off and made sure I...

well I took the upper intake off and made sure I scraped all the old gasket off and I put some of that brushabul gaskit stuff on it so theres no way im going to have a vacume leak there and im pritty...
Forum: 2nd Generation 09-14-2011, 01:13 AM
Replies: 7
Views: 2,918
Posted By sidewaysFC
Thumbs up Thats a way to go

Thats a way to go
Forum: 2nd Generation 09-13-2011, 02:43 AM
Replies: 7
Views: 2,918
Posted By sidewaysFC
well n/a's have 2 extra intake ports that open up...

well n/a's have 2 extra intake ports that open up in the higher rpms and stay closed in the lower rpm to keep your low end torque.also n/a's have baffles in the exhaust ports that would hinder the...
Forum: TECH Support 09-12-2011, 06:24 AM
Replies: 4
Views: 3,792
Posted By sidewaysFC
ok pulled it down the road 2 day with my friends...

ok pulled it down the road 2 day with my friends truck poped the clutch fired up no prob. but it wouldnt stay running even after I got it wormed up and I had the idle screw all the way up so I...
Forum: 2nd Generation 09-10-2011, 05:25 AM
Replies: 9
Views: 5,523
Posted By sidewaysFC
definetly drifting makes ur engine heat up faster...

definetly drifting makes ur engine heat up faster sins your going sideways you dont get as much air flow over the rad so you get hotter. if your going to be doing some hard core drifting stock shit...
Forum: TECH Support 09-09-2011, 02:20 AM
Replies: 4
Views: 3,792
Posted By sidewaysFC
also the gas in the tank is like a year old could...

also the gas in the tank is like a year old could a fresh moter not want to start on year old gas.
Forum: TECH Support 09-07-2011, 03:29 AM
Replies: 4
Views: 3,792
Posted By sidewaysFC
So close !!!

I just put my large street ported na moter in my 88 rx7 and it almost wants to start ill crank it and it will spuder like it wants to start or it will flood I by passed all the emissions as well and...
Forum: TECH Support 09-04-2011, 07:59 PM
Replies: 1
Views: 3,303
Posted By sidewaysFC
Also my power windows wount work so its my dash...

Also my power windows wount work so its my dash lights marker lights and windows that wount work and I got the engine in and harness hooked up so its not that. I have no idea so any idea I have no ac...
Forum: 3rd Generation 09-04-2011, 07:51 PM
Replies: 6
Views: 3,816
Posted By sidewaysFC
Dont confront them my ass some one trys to take...

Dont confront them my ass some one trys to take my rx7 there will be a little street justice going down.
Forum: 2nd Generation 09-03-2011, 09:57 AM
Replies: 4
Views: 2,066
Posted By sidewaysFC
not realy you would have way 2 much air coming...

not realy you would have way 2 much air coming in, i mean it mite be possibul but ive never herd of any one doing that and you would have to figure out an intake manifold for such a set up. a bridge...
Forum: 2nd Generation 09-01-2011, 09:22 PM
Replies: 4
Views: 2,066
Posted By sidewaysFC
Well any rx7 1985 and up is going to have a 13b...

Well any rx7 1985 and up is going to have a 13b .and a bridge port is were you make a slit going alonge the main port it will give you realy good top end power and an idle that sounds like BRAP BRAP...
Forum: 2nd Generation 09-01-2011, 04:45 AM
Replies: 9
Views: 5,523
Posted By sidewaysFC
A second gen rx7 is a very good car for drifting...

A second gen rx7 is a very good car for drifting I have 2 88 rx7s my self and I love drift them it pritty much my biggest love in life. you dont really need to go to a 20b unless you realy wanted to,...
Forum: 2nd Generation 08-25-2011, 04:27 AM
Replies: 5
Views: 2,489
Posted By sidewaysFC
all rx7s do this as far as i know its called the...

all rx7s do this as far as i know its called the accelerated worm up system it helps the engine worm up faster and helps it build oil pressure when u start it cold.
Forum: TECH Support 08-23-2011, 12:57 AM
Replies: 1
Views: 3,303
Posted By sidewaysFC
dash lights

I was installing some gauges on my white 88 rx7 to day and hooked up the battery and noticed my dash lights and markerlights were not working and I was thinking it could be because somthing like the...
Showing results 1 to 25 of 145

 
Forum Jump