Rx7 Forum and Owners Club - View Single Post

302rx7 · 06-26-2011, 03:51 AM

Hello everyone , im building a 88 convertible with a 5.0 t5 tranny.
when i slid in the motor and tranny today it was a little tight around the bell housing, the cross member was to high up. i dont have a problem cutting and modifying the cross member but thought it would be wise to hear other opinions and if theres a trick around it. i decided to fab up the tranny mount as well as the engine mounts. any help would be great.

06-26-2011, 03:51 AM	#1
302rx7 Junior Member Join Date: Jun 2011 Age: 35 Posts: 1	2nd gen convertible 5.0 ford swap. Hello everyone , im building a 88 convertible with a 5.0 t5 tranny. when i slid in the motor and tranny today it was a little tight around the bell housing, the cross member was to high up. i dont have a problem cutting and modifying the cross member but thought it would be wise to hear other opinions and if theres a trick around it. i decided to fab up the tranny mount as well as the engine mounts. any help would be great.