Hi There
New to this forum and rotarys. Had a 240sx for many years, now I have an 86 rx7. Trying to Find a good place to purchase manifold/turbo gaskets as I have a new turbo to install but no gaskets.
I copied and pasted info from the F/S add of the car I bought:
Engine/drivetrain:
87 Jspec streetported and rebuilt by Mitch formally at Atkins Rotary
RC engineering 1200cc primary injectors
RC engineering 750cc secondary injectors
Walbro 255lph fuel pump
BNR stage 3 turbo (S5 hotside-T04 cold hybrid good for 350+ WHP@15psi)
TII trans, driveshaft, rear diff, half shafts
6 puck cerametalic clutch
1700lb pressure plate
corksport 3" Downpipe
HKS 3" single back (drivers side exit...sounds amazing by the way)
Microtech LT10s EMS (tuned on stock turbo@8psi by Archer Racing)
+ Microtech handcontroller for quick tuning
body:
full S5 conversion kit(bumpers f/r, moldings, TII side skirts)
wiperless rear hatch(window)
suspension:
racing beat race springs(1.5" drop all around...stiff but comfortable)
tokico blue struts
racing beat f/r sway bars
misc.:
medium sized FMIC
HKS SSQ blow off Valve
relocated batt in Drivers side bin
Motor has ~7500 miles on it car has about 105,000.
This Forum isnt as active as I had hoped.. Hopefully it will pick up. I am in the market for some Coilovers, different wheels, Seats and S5 Tails for my car, would love to find some used deals. I also have a ton of extra parts the car came with I need to unload....
| 
Linear Mode
