Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > General RX-7 Area > How-To's

How-To's Fixing your RX..and need some help. Check out the how-to's here for any help ya need!!


Reply
 
Thread Tools Display Modes
Old 01-27-2009, 07:51 PM   #1
SmokeScream
Junior Member
 
Join Date: Jan 2009
Age: 42
Posts: 2
Default need help with code 13 on 90 gxl
just got this car a week ago. havent really drove it as i have been fixing problems here and there. taillights and dashlights didn't work. after putting new connector in headlight plug they came back. idle is a little bouncy when warm. took it out for a quick spin and engine light started to flicker when i was on the throttle. when i got back it didnt want to run unless i gave it gas. pulled codes and got 13 (pressure sensor) and 30 (split air valve). code 30 might be because some previous owner pulled out air pump and 6pi actuators. is the oe vac line for pressure sensor hard plastic? thats whats in my car. i've read there's supposed to be a plastic restrictor pellet in the vac line. someone also said they had that problem with a cold air intake and when it was cold out. any ideas?
SmokeScream is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump