Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 1st Generation

1st Generation 1979-1985 Discussion


Reply
 
Thread Tools Display Modes
Old 04-01-2004, 03:53 AM   #1
Jay
Full Access Member
 
Join Date: Mar 2004
Location: South of Heaven
Posts: 53
Send a message via AIM to Jay
Default Stock sway bar size?
What's the stock swaybar size on the FBs?


__________________
Jay™


www.momentumsportcompacts.com
Jay is offline   Reply With Quote
Old 05-04-2004, 03:54 AM   #2
rx7gslse
Full Access Member
 
Join Date: May 2004
Location: Ft Worth, TX
Posts: 52
Send a message via AIM to rx7gslse
Default
stock? little

the 12a cars have a smaller bar than the -SE's.

The one you want is the 1 1/8" bar from Mazdacomp, Racingbeat or others...


__________________
2004 Mazdaspeed MX-5 - Wheee Turbo!
1984 GSL-SE - My baby
2002 Protege5 - Lucky the drunk wagon [sold]
1989 Suburban - 4" lift, 33" BFGs etc - The Drunk tank!

How can I be so thirsty this morning, When I drank so much last night??
rx7gslse is offline   Reply With Quote
Old 05-06-2004, 09:29 AM   #3
mar3
Junior Member
 
Join Date: May 2004
Location: So. Arlington, TX!
Posts: 20
Send a message via AIM to mar3
Default
24 or 25 mm up front, I'll measure the back bar tomorrow and confirm the front size, too...


__________________
1983 RX-7 GS
1984 RX-7 GS
and a couple of 1968 Pontiac Firebirds, one a convertible and the other's an old-school Pro-Streeter...
mar3 is offline   Reply With Quote
Old 05-07-2004, 05:53 AM   #4
mar3
Junior Member
 
Join Date: May 2004
Location: So. Arlington, TX!
Posts: 20
Send a message via AIM to mar3
Default
oooops, forgot all about this...turns out the front bar is 23 mm for a GS and the rear is 21 MM...that's 0.909 inches up front and 0.837 inches in rear as measured with a vernier caliper...
mar3 is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump