Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Search Forums
Reload this Page Search Results
Become a Supporting Member         Become a Preferred Vendor


Showing results 1 to 4 of 4
Search took 0.03 seconds. Search: Posts Made By: EB Turbo
Forum: 3rd Generation 02-08-2012, 09:44 PM
Replies: 2
Views: 5,204
Posted By EB Turbo
Check your turbo outlet pipes. Early cars have a...

Check your turbo outlet pipes. Early cars have a coupler that likes to pop off. Later cars switched to a hard style 2 bolt flange.

Watch your PIM, if it does not move when you rev the car your MAP...
Forum: 3rd Generation 02-08-2012, 09:36 PM
Replies: 8
Views: 8,121
Posted By EB Turbo
You can still have good compression in total but...

You can still have good compression in total but have a low one or two sides. I have seen side seals stick on newly rebuilt engines that caused a misfire at idle but would drive fine. Find a shop...
Forum: 3rd Generation 02-08-2012, 09:32 PM
Replies: 1
Views: 4,589
Posted By EB Turbo
What are you working with? Pictures? EB...

What are you working with? Pictures?

EB Turbo
Forum: 3rd Generation 02-08-2012, 09:30 PM
Replies: 5
Views: 6,972
Posted By EB Turbo
Once you replace the intake and both of the...

Once you replace the intake and both of the catalytic converters you will need a tune or your car will detonate. The Rotary engine cannot take much or sometimes any at all before engine failure. Good...
Showing results 1 to 4 of 4

 
Forum Jump

Vendors
Auto Accessories Garage
RockAuto