Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 1st Generation
Reload this Page ENgine change
Become a Supporting Member         Become a Preferred Vendor

1st Generation 1979-1985 Discussion


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-23-2005, 05:29 AM   #2
AusTexRex
Full Access Member
 
Join Date: Apr 2004
Location: Austin & Waco Texas
Posts: 553
Send a message via AIM to AusTexRex
Default
Sorry it's taken so long for me to respond to this but there would be a few things involved in this.
You'd need a custom tranny bell, driveshaft, motor mounts. a new ecu, and pretty much the works, you might also be sacrificing your near 50/50 weight dist to do this.
AusTexRex is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


Vendors
Auto Accessories Garage
RockAuto