Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 2nd Generation

2nd Generation 1986-1992 Discussion


Reply
 
Thread Tools Display Modes
Old 07-28-2010, 02:12 AM   #1
BioNuke
Junior Member
 
Join Date: Jul 2010
Age: 39
Posts: 5
Default Diagnostic question...
Hey guys I used to have an account on here but I don't remember my info for it so I just had to make a new one. I have an 88 'vert sittin pretty at 240k miles original and recently It's been starting to make some funny sounds... The main ones are a high pitched squeal between 45 and 60 (the whole ways then goes away above and below that) doesn't matter which gear or clutch in/out, a loud "thunk" occasionally when letting out the clutch that usually only happens when the car is cold, and finally a loud humming sound when driving that almost sounds like regular tire sounds but alot louder and doesn't change really with speed. That last one is also in any gear incl. neutral with the clutch in or out and usually only makes that sound during the hottest part of the day (I live in the desert so thats been 110 or so lately). I wont have time to work on it for about a month cuz I'm in the process of moving but I'd appreciate any advice/diagnostic help you guys can offer.
BioNuke is offline   Reply With Quote
Old 07-29-2010, 11:34 AM   #2
 
black rocket's Avatar
black rocket
Full Access Member
 
Join Date: May 2004
Location: NV
Posts: 1,059
Default
Sounds to me like throwout bearing. And, when was the last time you change your gear oil?


__________________
Drive safe and Sane
black rocket is offline   Reply With Quote
Old 07-30-2010, 03:51 AM   #3
BioNuke
Junior Member
 
Join Date: Jul 2010
Age: 39
Posts: 5
Default
I replaced the whole clutch including the throwout bearing and changed the oil in both the tranny and rear differential @ 190k and changed the oils again at 235k... I added lucas to the oils this last time as well... Is there a way to test the throwout bearing to make sure thats it without taking it apart? I dont have a garage so it's kind of a pain to do
BioNuke is offline   Reply With Quote
Old 07-30-2010, 06:25 AM   #4
 
black rocket's Avatar
black rocket
Full Access Member
 
Join Date: May 2004
Location: NV
Posts: 1,059
Default
Did you resurfaced your flywheel and follow the clutch mfr's break in process? I drove like a grandma when I was breakingin my new clutch. How's your slave cylinder?


__________________
Drive safe and Sane
black rocket is offline   Reply With Quote
Old 07-30-2010, 07:21 AM   #5
BioNuke
Junior Member
 
Join Date: Jul 2010
Age: 39
Posts: 5
Default
I didn't resurface the flywheel... Didn't think about it at the time to be honest... That was my first time ever changing a clutch. I've had to replace the master and slave cylinders both probably between 205 and 210k... both had developed leaks. For the break-in it's been awhile but I remember I had to drive nice for awhile. The clutch did slip on me a couple times during that but it hasn't done that since then. I was having to drive about 1.5 miles each way on the worst road I've ever seen for work for a couple years but my job just changed locations so I don't have to do that anymore. I had to replace all my shocks and 1 wheel bearing from that. I was wondering if it might be something in the suspension. I need to replace my brake pads but I don't know what to look for with sway bars, stabilizer arms, bushings, etc to tell if something's wrong there.
BioNuke is offline   Reply With Quote
Old 07-30-2010, 06:13 PM   #6
 
black rocket's Avatar
black rocket
Full Access Member
 
Join Date: May 2004
Location: NV
Posts: 1,059
Default
Have you ck'd your tranny mount? By the time I got to it after shattering my clutch disk there weren't much left for any kind of support.

I, then replaced my tranny mount with semi-solid ones. After that it shifts so much better.


__________________
Drive safe and Sane
black rocket is offline   Reply With Quote
Old 07-30-2010, 06:13 PM   #7
 
black rocket's Avatar
black rocket
Full Access Member
 
Join Date: May 2004
Location: NV
Posts: 1,059
Default
Have you ck'd your tranny mount? By the time I got to it after shattering my clutch disk there weren't much left for any kind of support.

I, then replaced my tranny mount with semi-solid ones. After that it shifts so much better.


__________________
Drive safe and Sane
black rocket is offline   Reply With Quote
Old 07-31-2010, 02:36 AM   #8
BioNuke
Junior Member
 
Join Date: Jul 2010
Age: 39
Posts: 5
Default
lol thats funny you shattered your clutch too... I replaced mine cuz I shattered the disk shifting into 3rd with my RPM gauge pegged... I think it was around 9k RPM but the gauge goes to 8 so... that was fun til it blew up lol! the mount is there but I need a new rubber seal between the top of the tranny and the body where the shifter comes through and probably should replace whatever rubber parts cushion the underside. On the way to work today I had my speedometer go dead on me and power steering go out at about the same time... I think it was just coincidence. I haven't taken a look at it yet but I think possibly the power steering just needs fluid... the speedometer cable disconnected itself from the tranny tho I know... it was dragging for a bit so I'm gonna have to tap it back into a circle to get it back on the threads now I'm thinking maybe it was the speedometer cable making the squeal, and maybe power steering making the other sound... It's odd tho cuz it didn't make the sound on corners when I was actually turning the wheel. I checked the fluid a few weeks ago so I'm thinking maybe it started leaking since then... I'm gonna go take a look at it now so we'll see
BioNuke is offline   Reply With Quote
Old 07-31-2010, 07:34 AM   #9
 
black rocket's Avatar
black rocket
Full Access Member
 
Join Date: May 2004
Location: NV
Posts: 1,059
Default
LOL Yeah, I was just playing around at the last light when I smoked some yahoo 2 lights in a row and I was simply smoke him and as I shift from 2nd to 3rd I couldn't engage anything thinkingI must've smoked the clutch. Cked thru inspection access and pieces


__________________
Drive safe and Sane
black rocket is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump