Welcome to the Rx7 Forum and Owners Club.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>


Go Back   Rx7 Forum and Owners Club > Specific RX-7 Models > 3rd Generation
Reload this Page Boost Issues
Become a Supporting Member         Become a Preferred Vendor

3rd Generation 1993-Current Discussion


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-08-2012, 09:44 PM   #3
EB Turbo
Junior Member
 
Join Date: Feb 2012
Location: Santa Monica, CA
Posts: 4
Send a message via AIM to EB Turbo
Default
Check your turbo outlet pipes. Early cars have a coupler that likes to pop off. Later cars switched to a hard style 2 bolt flange.

Watch your PIM, if it does not move when you rev the car your MAP sensor could be unplugged. Also look in the boost settings table. What are the values? even if they are zero you should still be making spring pressure boost. To have zero boost you must have a boost leak.

EB Turbo
EB Turbo is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


Vendors
Auto Accessories Garage
RockAuto